New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
Cables and com ports,I found the link to the cables on Amazon I think from this topic. They have worked fine so far.On the com port, somehow my PC device decided to add a com port. Now I have two to chose from. Sometimes the first one listed works, sometimes the second one. Try both ports before giving up.Good luck,Tom
Is it like that at normal operating temperature too? In your picture it shows an engine temperature of 59 degrees. I guess this is just a coincidence but the lambda signal is ignored by the ECU below 60 degrees.You now have a map with the lambdas switched off, so it isn't currently a problem, but I would have thought that if your lambda really was defective, you would have got an error message on the stock map.+16 CO Trim?? Is that the recommendation for the map?John
Larry, I just sent you the very latest map with your speedo correction. Try it at CO=0 first and let me know.I suspect something else it happening with regard to the rough idle. How's your TB balance?
Few months and it was fine for me but being my paranoid self thinking I may of screwed something up!
If you're going to keep using my map, you won't need a new lambda. The map is open loop, so the lambda signals are ignored. You will still get an error, however, if the lambda sensor heater fails.I would ignore the fact the second lambda shows no signal. There's something else amiss, either with the tune, or the map.
Thanks Larry. I'll sleep better now.When you try the stock map, if it idles fine straight up, we can only assume your bike doesn't like my map.