Wildguzzi.com
General Category => Bike Builds, Rebuilds And Restorations Only => Topic started by: TheBru on February 22, 2017, 01:40:06 PM
-
For under the rocker arm support and cylinder. I was going to get my gasket set from MG Cycles but I don't see theses o rings. Harper has them but I hate to just buy this amount from them. Are there any readily available substitutes? If so, what is the size I would be asking for??
Thanks.
-
http://www.mgcycle.com/index.php?main_page=product_info&cPath=117&products_id=4830
You can also use these: https://www.mcmaster.com/#9464k17
If you want a set of those clutch pushrod o-rings I offered in your other thread, I could send you 12 of the cylinder stud o-rings with them.
-
If you want a set of those clutch pushrod o-rings I offered in your other thread, I could send you 12 of the cylinder stud o-rings with them.
Yes!!! I do appreciate it. I don't know how I missed those on the MG site. But I will certainly take you up on your offer. I will email you my address right now. Just tell me you got it.
(http://thumb.ibb.co/jy2HAa/Guzzi.jpg) (http://ibb.co/jy2HAa)
-
Yes!!! I do appreciate it. I don't know how I missed those on the MG site. But I will certainly take you up on your offer. I will email you my address right now. Just tell me you got it.
(http://thumb.ibb.co/jy2HAa/Guzzi.jpg) (http://ibb.co/jy2HAa)
Got it. Will send the o-rings out a.s.a.p. - probably Friday morning.