Wildguzzi.com

General Category => General Discussion => Topic started by: TOMB on October 30, 2016, 01:12:49 PM

Title: Part numbers for pre 1991 calif cruisrers ring and pinion 6/32 ratio
Post by: TOMB on October 30, 2016, 01:12:49 PM

Im looking for the part numbers for the ring and pinion that is for the optional gearing (for cruising around town).

In Guzziology the ref is in pg. 14-6 and indicates the tooth count of 6/32 for a ratio of 5.333

I have a lot of parts manuals but I cant find any part numbers for this application . Pinion end has 20 teeth and requires a

special coupling  (10 teeth  for driveshaft end and 20 teeth for the pinion end ) Im sure that this is low demand low need item

but any assistance will greatly welcomed.

Thanks in advance

TOMB

Title: Re: Part numbers for pre 1991 calif cruisrers ring and pinion 6/32 ratio
Post by: TOMB on October 30, 2016, 02:32:09 PM

I found a part number in a micro fiche 1735-4690 (ring and pinion ) can anyone please verify For 1987 Cal 111 .

Thanks

TOMB

Title: Re: Part numbers for pre 1991 calif cruisrers ring and pinion 6/32 ratio
Post by: guzzisteve on October 30, 2016, 02:39:06 PM

It is in LeMans II workshop Man on page 169 #17354690 same PN, I think it has the Convert/5sp coupler PN also but good luck finding one.

Title: Re: Part numbers for pre 1991 calif cruisrers ring and pinion 6/32 ratio
Post by: TOMB on October 30, 2016, 05:06:58 PM

Thanks Steve could you also provide the part # for the coupler for the drivehaft
To pinion. It's 10 teeth on one end and 20 on the other end.
Thanks
TOMB

Title: Re: Part numbers for pre 1991 calif cruisrers ring and pinion 6/32 ratio
Post by: guzzisteve on October 30, 2016, 06:32:21 PM

OK, it says "to be mounted with double cardan joint #14328040 and sleeve #18327700"

Sorry, I was trying to fit a Centy wheel on a Tonti swingarm. It's real tight, I will have to remove the rear drive to change wheel and make a brakeplate.

Title: Re: Part numbers for pre 1991 calif cruisrers ring and pinion 6/32 ratio
Post by: TOMB on October 30, 2016, 07:51:34 PM

Thank you
TOMB