General Category > General Discussion

V7 II Oil seeping from engine case halves

<< < (2/3) > >>

Kev m:

--- Quote from: guzzisteve on August 25, 2026, 05:28:10 PM ---Book says just under 17ftlbs on the studs. Bout the same as the early smallblocks. The bead of sealer does not look like a factory bead, specially the glob in the middle. Could it be one that had the crank wear shims issues? Can't remember what year model those are.

--- End quote ---

The issue was undersized machined crankshafts. And yes it's only on a small rib of 2016 V7II's.

Unless this one had the crankshaft prophylactically replaced it would likely have been too late once otherwise discovered through symptoms. Though I guess anything is possible.

MarinerRime:

--- Quote from: Dirk_S on August 25, 2026, 04:09:53 PM ---You’re not blind, it’s listed in the specific engine manual, not the primary factory service manual. You can download the engine manual from Cadre Cycle’s website, Guzzitek.org, or Greg Bender’s thisoldtractor.com. Here’s a link from Cadre Cycle to download:

https://cadrecycle.com/manuals/technical/Engine%20V750%20IE%20MIU%20G3.pdf

--- End quote ---

I did get my coffee in me and found an engine manual for the 13-14 v7's that helped answer my question finally but thanks for the link.

MarinerRime:

--- Quote from: Dirk_S on August 25, 2026, 04:11:59 PM ---How many miles does your V7 II have? The weeping crankcase has my suspicions slightly aroused considering the V7 II’s notorious crankshaft issue.

--- End quote ---
It's right at 11400. I loosened and re-tightened using locktite and the factory torque setting as a guide. We'll see if that does it. This bike was pretty neglected IMO but doesn't have any of the clutch issues I've read about with other 2016's. I dropped the pan and there was no glitter so that was encouraging in spite of it being low on oil.

MarinerRime:

--- Quote from: guzzisteve on August 25, 2026, 05:28:10 PM ---Book says just under 17ftlbs on the studs. Bout the same as the early smallblocks. The bead of sealer does not look like a factory bead, specially the glob in the middle. Could it be one that had the crank wear shims issues? Can't remember what year model those are.

--- End quote ---

2016's which is what mine is. I was suspect of the sealant too, never seen one like that. Very well could be an engine that the dealer fixed or someone else picked up and had their way with. I got a pretty good deal on it and it runs well so we'll see.

MarinerRime:
So it's been a week and so far so good. I've found more loose bolts and nuts on this thing than any bike I've owned.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version