General Category > General Discussion
He's back, hopefully!
Groover:
What other parts is he making? I saw that lever, and it looks sharp. I may grab one at some point, maybe after I'm done doing the other one thousand five hundred things to my bike..
dilligaf:
I purchased some nice MG belt buckles fro Joe at the VA Rally some years ago. Very nice. :BEER:
Matt
Antietam Classic Cycle:
--- Quote from: Groover on April 03, 2015, 10:30:14 AM ---What other parts is he making?
--- End quote ---
He used to make fin/head guards, choke levers, Loop sidecover knobs, spine frame shift levers, belt buckles and more.
cruzziguzzi:
--- Quote from: Rich A on April 03, 2015, 08:51:27 AM ---I saw a machined choke/enrichener lever for sale on Ebay and bought one. Turns out it was some old stock from Joe Kenney. I sent Joe a message, and he said that he may be making some parts again in the future. Good news, I think, as his parts were very nice.
Rich A
--- End quote ---
Is this by any chance useable on a '95 Spot 1100? My plasticky one broke in what,... '98. I'd love to get one of stiffer stuff than the original.
Todd.
Antietam Classic Cycle:
--- Quote from: cruzziguzzi on April 03, 2015, 12:36:06 PM ---Is this by any chance useable on a '95 Spot 1100? My plasticky one broke in what,... '98. I'd love to get one of stiffer stuff than the original.
Todd.
--- End quote ---
Joe's choke lever will work on the Dellorto flip chokes (on the carbs) or on the 2-into-1 choke actuators like this:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version