Author Topic: loop 4 speed shimming  (Read 369 times)

Online lazlokovacs

  • Gaggle Hero
  • *****
  • *
  • Posts: 1079
loop 4 speed shimming
« on: January 30, 2021, 10:25:46 AM »
rear shifter is a little bit (0.8mm) worn on the 1st gear side...

which means I should move the drum forwards

BUT there in no shim on the front side of the shifter drum.

Could I move a shim from the rear to the front end of the output (lay)shaft to compensate?

Cheers



 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here