« previous next »
Pages: [1]   Go Down

Author Topic: loop 4 speed shimming  (Read 372 times)

Offline lazlokovacs

  • Gaggle Hero
  • *****
  • *
  • Posts: 1084
loop 4 speed shimming
« on: January 30, 2021, 10:25:46 AM »
rear shifter is a little bit (0.8mm) worn on the 1st gear side...

which means I should move the drum forwards

BUT there in no shim on the front side of the shifter drum.

Could I move a shim from the rear to the front end of the output (lay)shaft to compensate?

Cheers


Logged
Quad Lock - The best GPS / phone mount system for your motorcycles, no damage to your cameras!!
Get a Wildguzzi discount of 10% off your order!
http://quadlock.refr.cc/luapmckeever
Advertise Here
Pages: [1]   Go Up
« previous next »
 

Quad Lock - The best GPS / phone mount system for your motorcycles, no damage to your cameras!!
Get a Wildguzzi discount of 10% off your order!
http://quadlock.refr.cc/luapmckeever
Advertise Here