Author Topic: New rear shock for Griso  (Read 1696 times)

Offline Birch71

  • Vrrrroooooommmmer
  • Hatchling
  • **
  • Posts: 191
  • Getting paid to shoot people
    • I Shoot People
  • Location: Chicago
New rear shock for Griso
« on: July 10, 2015, 09:55:06 AM »
So I just picked up a new rear shock for the Griso. Question is, can I install it myself?

I'm mechanically inclined and good at following directions, but no formal training here (AKA, I don't know what the hell I'm doing!)

For those who have done it, what do I need in terms of a lift to get the rear off the ground? So far, I only have a front wheel stand, so I'd be starting fresh here. I have installation instructions, but those start once the rear wheel is off the ground.

My garage does not have direct access to the beams (drywall ceiling).

Thanks everyoneE!!
I shoot people and make mom's cry- can't believe they pay me for it!

Offline jcctx

  • Gaggle Hero
  • *****
  • Posts: 1500
  • Location: Parker, Collin Cty., TX
Re: New rear shock for Griso
« Reply #1 on: July 10, 2015, 10:09:09 AM »
Rent an engine lift from the rental shop for the 3 or 4 hrs. needed!!

Offline malik

  • Gaggle Hero
  • *****
  • Posts: 2377
  • Location: Sydney, Australia
Re: New rear shock for Griso
« Reply #2 on: July 10, 2015, 07:38:56 PM »
For more info, get onto Griso Ghetto (grisoghetto.com). Beetle's recently done that very thing & this site is a fount of experience and wisdom of things Griso.

Mal
2010 V7 Classic, 2014 V7 Special
1996 1100 Sport Carb (in NZ), 2004 V11 LeMans (in UK)
Carberry Enfield V-Twin, 2008 Royal Enfield Electra, 2006 RE Electra 535

Vasco DG

  • Guest
Re: New rear shock for Griso
« Reply #3 on: July 10, 2015, 07:42:38 PM »
Griso is rear heavy. Tie the front down and jack up using a broad support under the sump. Once the shock is fully extended disconnect the linkage to the frame and then you can undo first the bottom mounting bolt, then the upper and wriggle the shock out.

Better yet pull the swingarm and grease the swingarm bearings and shock linkages as they will likely be dry but this might be a bit too much for a novice,

Pete

Wildguzzi.com

Re: New rear shock for Griso
« Reply #3 on: July 10, 2015, 07:42:38 PM »

Offline ohiorider

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • *
  • Posts: 8086
  • "You can't fight in here - this is the War Room."
Re: New rear shock for Griso
« Reply #4 on: July 10, 2015, 10:18:43 PM »
So I just picked up a new rear shock for the Griso. Question is, can I install it myself?

I'm mechanically inclined and good at following directions, but no formal training here (AKA, I don't know what the hell I'm doing!)

For those who have done it, what do I need in terms of a lift to get the rear off the ground? So far, I only have a front wheel stand, so I'd be starting fresh here. I have installation instructions, but those start once the rear wheel is off the ground.

My garage does not have direct access to the beams (drywall ceiling).

Thanks everyoneE!!

Not a direct answer to your question, but if you intend to keep the Griso for an extended ownership, consider one of these.  I picked one up shortly after bringing the Griso home, and it has been invaluable for routine maintenance, tire changes,
etc.

http://www.mgcycle.com/index.php?main_page=product_info&products_id=3017


Main ride:  2008 Guzzi 1200 Sport (sold July 2020)
2012 Griso 8v SE (sold Sept '15)
Reliable standby: 1991 BMW R100GS
2014 Honda CB1100 (Traded Nov 2019)
New:  2016 Triumph T120 (Traded Dec 2021)
New:  2021 Kawasaki W800

 

Quad Lock - The best GPS / phone mount system for your motorcycles, no damage to your cameras!!
Get a Wildguzzi discount of 10% off your order!
http://quadlock.refr.cc/luapmckeever
Advertise Here