Author Topic: 1100SS #8 is done  (Read 1177 times)

Offline MotoGzziClassics

  • New Egg
  • *
  • Posts: 16
  • Location: Signal Hill, Ca
1100SS #8 is done
« on: February 09, 2022, 11:24:00 AM »
Mark just knocked out his 8th 1100SS builds. Bike started out as a 98 EV, took about 2wks start to finish minus a small hiccup where the computer failed and had to get replaced. I took it out yesterday on its maiden voyage and seems to hard good, small misfire going on and some backfires. Mark is going to mess with the TPS sensor and hopefully fix the issue. Hope you enjoy

Wyatt and Mark
Moto Guzzi Classics









Online AJ Huff

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • *
  • *
  • Posts: 4069
  • Location: College Community IA
Re: 1100SS #8 is done
« Reply #1 on: February 09, 2022, 11:52:48 AM »
Nice!!!

-AJ
'71 Ambassador
'01 California Special
'05 Road King
MGNOC# L-753

Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 14141
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: 1100SS #8 is done
« Reply #2 on: February 10, 2022, 08:51:30 AM »
 :thumb: :thumb:
Charlie

Offline Scout63

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • *
  • *
  • Posts: 2682
  • Location: Orleans, MA USA
Re: 1100SS #8 is done
« Reply #3 on: February 10, 2022, 09:43:37 PM »
Nice looking bike.
Ben Zehnder - Orleans, MA USA

Wildguzzi.com

Re: 1100SS #8 is done
« Reply #3 on: February 10, 2022, 09:43:37 PM »

Offline Groover

  • Gaggle Hero
  • *****
  • *
  • Posts: 2855
  • If it ain't broke, I'll break it.
    • Scooteropolis
  • Location: Columbus, Ohio
Re: 1100SS #8 is done
« Reply #4 on: February 15, 2022, 08:15:47 AM »
Looks great! How are the front fork tubes being lowered? Are those cut or replacement, or am I just seeing something that is not there?  :azn:
1981 Moto Guzzi V1000G5
1987 Moto Guzzi LM1000SE, a
1987 Moto Guzzi LM1000SE, b
1980 Piaggio Vespa P200E
1980 Piaggio Vespa P125X
1980 Vespa Grande Moped
1980 Vespa SI Moped
http://scooteropolis.com/

Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 14141
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: 1100SS #8 is done
« Reply #5 on: February 15, 2022, 08:58:07 AM »
Looks great! How are the front fork tubes being lowered? Are those cut or replacement, or am I just seeing something that is not there?  :azn:

Looks like they've been raised about an inch through the triples.
« Last Edit: February 24, 2022, 08:42:13 AM by Antietam Classic Cycle »
Charlie

Offline s1120

  • Gaggle Hero
  • *****
  • Posts: 2161
Re: 1100SS #8 is done
« Reply #6 on: February 24, 2022, 06:19:03 AM »
Looks nice!  That was my plan for when I found a Cali Guzzi but I ended up finding one too cool, and nice to take apart. So the next one I find will be the project!
Paul B

 

20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here