New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
Sorry, no parts book to look at and the number does not come up on a search for me, but, what is directly below the instrument bracket on my SP are sort of studs with a female threaded end on the upper part. The stud part goes through the lower (cast in) handlebar clamps at the front and the female part (upper) gets 8mm bolts to hold down the instrument bracket through. The CX/ LM2 uses spacers as a conventional bar is not used therefore no upper half shell clamps. Measurements I got so far: spacer part is 50mm from top of upper handlebar clamp to under the instrument bracket plate. then add another 10mm from the bottom handlebar clamp ( cast in the top triple) through the top half shell clamp. Hope that helps
Can you photograph the parts? I’m sure I have them if Clifford can bear another package. Ben
___________________ _________________
As above, I have all my original LM2 dash parts in a box on the shelf so could easily measure anything - if I knew what part we were talking about!