General Category > General Discussion

Guzzidiag Reader: Initialization Failed!

<< < (2/3) > >>

GuzziOrDeath:

--- Quote from: Huzo on November 24, 2022, 02:59:22 PM ---Are you absolutely certain you have the correct bike selected in the drop down menu ?
I once tried to re set the TGPS on the V85 for three hours with the Norge selected on Guzzidiag…. :embarrassed:

--- End quote ---


Won't connect with the Reader, so that's irrelevant.

Huzo:

--- Quote from: GuzziOrDeath on November 24, 2022, 04:16:14 PM ---
Won't connect with the Reader, so that's irrelevant.

--- End quote ---
Ok.

lewisham_phil:
Thanks for the replies guys. I've just run the Adapter Test, and it passes fine. Guzzidiag also connects fine; I have selected 'V7 Stone' as recommended in the instructions (mine's actually a V7 2012 1TB Special). Tried the Reader again (after quitting GuzziDiag), I notice the Transmit and Receive LED's on the Lonelec adapter flash every second (like they do when you run the adapter test), so seems to be connecting.. but same result,  Initialization failed.
What if I just try running the Writer, and upload Beetle's map? If I did need to go back to standard, I imagine it would be easy enough to find a standard original map? Although if the Reader isn't working maybe the Writer could wreak havoc!? 

Wayne Orwig:
I would be reluctant to just write something to the ECU, and risk bricking it if there was a problem.

Which reader are you using? I sounds like you aren't using the correct one since the test works, and GuzziDiag works.

lewisham_phil:
I'm running IAWMIUG3Reader_V0.0 5 , which is the one linked for 'the V7 & V9 Single Throttle Body MIU G3' in the instructions off the Griso.org site, which I think is up to date..

Navigation

[0] Message Index

[#] Next page

[*] Previous page