Author Topic: CX100 Restoration  (Read 1024 times)

Offline Dluke

  • New Egg
  • *
  • *
  • Posts: 4
  • Location: Bend, Oregon USA
CX100 Restoration
« on: August 15, 2021, 05:56:54 PM »
I am restoring a 1981 Lemans CX100. I am trying to source a new headlight which is a sealed beam unit. I have all of the mounting hardware (shown in photo) but the light itself was broken. I have been told that I can possibly try an automotive unit. If anyone has any guidance it would be very helpful. I have checked with all of the traditional sources, (MG, Harpers, Cycle Garden, Mark Etheridge, Greg Bender)


Online Antietam Classic Cycle

  • Gaggle Hero
  • *****
  • *
  • Posts: 14141
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: CX100 Restoration
« Reply #1 on: August 16, 2021, 08:34:58 AM »
Did you get my Message? Sent you a link to what I believe Rick was recommending. Are there any numbers printed on the back of the broken sealed beam unit?
https://www.sylvania-automotive.com/sylvania-h4656-basic-sealed-beam-headlight-1-pack/H4656.BX.html

You should really post this in "General Discussion", not "Bike Builds, Rebuilds And Restorations Only".
Charlie

Offline Dluke

  • New Egg
  • *
  • *
  • Posts: 4
  • Location: Bend, Oregon USA
Re: CX100 Restoration
« Reply #2 on: August 16, 2021, 11:49:52 AM »
Yes I did Charlie, thank you!

 

Quad Lock - The best GPS / phone mount system for your motorcycles, no damage to your cameras!!
Get a Wildguzzi discount of 10% off your order!
http://quadlock.refr.cc/luapmckeever
Advertise Here