Started my 8V Norge up today and heard what sounded like an exhaust leak at the left cylinder head, after putting my hand in around the pipe I could feel the air (exhaust ) pulsing around in there confirming what I suspected.
I'm assuming its going to take a few days to get the gasket in, my question is does anyone think it will damage anything to ride it the way it is for a day or so ???
prob not but will pop on overrun, excessive doing this could burn valves out, unlikely in days , it might fool the fool injection lamda sensor and run funny
But first try doing up exhaust, gaskets don't blow, they are simply neglected
If only just started doing it you might get it to seal in under a minute, also tighten the other side (should have been done at first service)
Don't know about 8V (Pete will chime in) but if as old Guzzi there is welded on flange at pipe end, this could break off (again usually because loose)
So, worth looking before ordering anything