I decided to share another way to do it , without taking que exhaust out , making possible to do it with the engine hot , making the old oil drain better.
Tool needed :
Scissor jack or equivalent to put the bike stand straight.
24 mm spanner
Some M5 hexagon bit or equivalent wrench to take exhaust cover.
Some hexagon bit or wrench to take filler cap.
Something to catch the oil below.
Funnel
Let's get started :
1 - Put the bike on jack , then
2 - Take the near lambda sensor exhaust cover with the M5 bit .
3 - Take the filler cap out.
4 - Taking the drain cap - Put the 24mm spanner between the exhaust pipe and the frame. HOLD IT in place with one hand , unscrewing with the other. Take the cap out and let it drain a bit , then take the filter out. Let it drain some time until it stops.
5 - Clean the filter with some degreser , like brake spray , also the caps.
6 - Put the filter in , the drain cap , screw it snug , don't need extreme force .
7 - Put the funnel into the fill hole and put 500ml of GL5 75/90 Gearbox oil.
8 - Put the filler cap and screw it snug.
9 - Put the bike down - Don't forget your side stand !!!
Enjoy your bike. :)
deduplicate list online