« previous next »
Pages: 1 [2]   Go Down

Author Topic: Removing crankshaft/camchain pulley nut on LM2...  (Read 9660 times)

Offline lucky phil

  • Gaggle Hero
  • *****
  • Posts: 2047
Re: Removing crankshaft/camchain pulley nut on LM2...
« Reply #30 on: July 23, 2015, 05:06:44 PM »
You should change the camshaft retainer while you're in there as it looks pretty worn. Get the updated version with the reliefs in the thrust face.
Ciao 
Logged
If you're not living on the edge you're taking up to much room.
20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here
Pages: 1 [2]   Go Up
« previous next »
 

Quad Lock - The best GPS / phone mount system for your motorcycles, no damage to your cameras!!
Get a Wildguzzi discount of 10% off your order!
http://quadlock.refr.cc/luapmckeever
Advertise Here