Wildguzzi.com

General Category => General Discussion => Topic started by: Rebochi on April 22, 2021, 05:49:17 PM

Title: Reaction rod question
Post by: Rebochi on April 22, 2021, 05:49:17 PM

  On my 08 1200S / 13 Griso Frankenstein bike  The reaction rod is 1 inch too short to slide back in place without preloading the shock a inch or two. The shock is a Penske. The Reaction rod is from the 2013 Griso  Part # 883046 with a eye to eye length of 17 inches. Anybody know the eye to eye length of a  1200S/ Norge reaction rod  Part # 977262 ?

Title: Re: Reaction rod question
Post by: Huzo on April 23, 2021, 05:55:52 AM

Can’t you grab the eye at the top of the arm protruding from the bevelbox and move it towards the end of the rod ?

Title: Re: Reaction rod question
Post by: Rebochi on April 23, 2021, 09:12:23 AM

   I  took the it back aprtr to figured out my mistake, the shaft was not on splines at the gear case so the reaction rod would not line up unless you compressed the suspension. Fixed now.