General Category > Bike Builds, Rebuilds And Restorations Only

850T Project Cafe Bike

<< < (4/5) > >>

cappisj1:
The gear shift side. I used the adaptor included in the kit. I had it welded to a new rod the replaced the original rod that runs under bike from side to side. Had to bend the tab in this side also.

twowings:
Tasty!  :bow:

swooshdave:

--- Quote from: cappisj1 on February 03, 2017, 02:50:04 PM ---The gear shift side. I used the adaptor included in the kit. I had it welded to a new rod the replaced the original rod that runs under bike from side to side. Had to bend the tab in this side also.





--- End quote ---

Would it have been easier to switch to right side shift?

canuck750:
Nice job!  Enjoy the ride.

arveno:

--- Quote from: cappisj1 on January 28, 2017, 12:16:12 AM ---Pulled both cylinders to check the chrome lining. All was good. Notice the high dollar ring compressor.




you decided you run the original cylinders ? Chrome bore ?

i am sure you know the story.... nice bike .
--- End quote ---

Navigation

[0] Message Index

[#] Next page

[*] Previous page