Recent Posts

1

General Discussion / Re: Set-screw size?

« Last post by Air-Cooled on Today at 10:04:21 PM »

Original Lucas signals had stems that were threaded 7/16-14.

I have an Aprilia signal somewhere around here, will have dig it out and measure the set screw.

They were used on some 850-Ts as far as I know.

Aprilias were also used on V7 Sports sold in Italy.  The one in their museum has them.  When I bought my V7 Sport many years ago, it came with no turn signals.  Lucas signals were standard on US V7 Sports.  I needed to add turn signals, so I figured why not go with the Aprilias?  They are made of metal, unlike the plastic Lucas ones. But I'd be very interested to know what your Aprilia signal takes for a set screw.  Thx!

2

General Discussion / Re: Set-screw size?

« Last post by Antietam Classic Cycle on Today at 09:44:04 PM »

Original Lucas signals had stems that were threaded 7/16-14.

I have an Aprilia signal somewhere around here, will have dig it out and measure the set screw.

They were used on some 850-Ts as far as I know. 

3

General Discussion / Re: Set-screw size?

« Last post by Air-Cooled on Today at 09:41:42 PM »

There has to be a parts fiche on the net some where that will give the information.

Been there, done that.  The set screw is not identified, no surprise there.

4

General Discussion / Re: Yesterday's big adventure

« Last post by 1wild1 on Today at 09:21:57 PM »

10.5 hours on the V85TT that day. Traffic was crazy from St. Louis going south on hwy55. Got some good shots though.

5

General Discussion / Re: Set-screw size?

« Last post by ridingron on Today at 09:18:28 PM »

What model are the turn signals from?

There has to be a parts fiche on the net some where that will give the information.

6

General Discussion / Re: Why multis are better - Nerd-alert!

« Last post by LowRyter on Today at 09:00:58 PM »

missing here

multis  <RPMs

7

General Discussion / Re: Knuckle Duster Head Protectors!

« Last post by Tom H on Today at 08:53:18 PM »

Guzzi Classics said he didn't have them as pictured.

Tom

8

General Discussion / Re: Breather hose on V7 Sport

« Last post by Air-Cooled on Today at 08:26:53 PM »

I use this hose: https://www.mcmaster.com/5235K55/ It's soft and flexible enough that it can be greased up and inserted through the metal holder fairly easily. I cut the end at a sharp angle which aids in inserting it through the holder.

Great info! I ordered one.  It must be a lot softer than Gates rubber if you were able to cut the end at a sharp angle.

9

General Discussion / Re: Set-screw size?

« Last post by Air-Cooled on Today at 08:23:56 PM »

Unfortunately, I used thread gauges at three different stores.  The only one that would accept it was a 10-32, but 10-32 screws will not fit into the turn signal.  That is the reason I posted the question here.  I hoped someone might have had to replace one and would know. 

10

General Discussion / Re: Breather hose on V7 Sport

« Last post by 73 sport on Today at 08:23:53 PM »

      ed is used in optics. od is used in mechanics.