Wildguzzi.com
General Category => General Discussion => Topic started by: berniebee on May 11, 2021, 09:00:03 AM
-
The new shift spring I'm installing won't stay sitting down flat on the selector mechanism. though I can easily push it down with my pinkie . It's as if I installed incorrectly, but it's not. I've tried it both ways. The other way is obviously wrong. (Wronger? :laugh:)
(https://i.ibb.co/P6ghbWv/20210511-095042.jpg) (https://ibb.co/P6ghbWv)
(https://i.ibb.co/z6VDj5N/20210511-095113.jpg) (https://ibb.co/z6VDj5N)
I noticed that this new spring is wound the opposite way of the original. See the pic, new spring on the left.
(https://i.ibb.co/HPZm9XD/20210511-094011.jpg) (https://ibb.co/HPZm9XD)
Looking for some assurance that I can go ahead with the spring as is. It's an '83 SP1000.
-
As long as both of the prongs of the spring engage the eccentric screw, then it won't be a problem. The rear cover will hold it flat once assembled.
-
Thanks Charlie!
-
nd now the final assembly begins :) . Peter