General Category > General Discussion
guzzidiag reader not connecting
vij:
I have a small issue. it is not a guzzi, sorry it is a ducati. Guzzidiag connects good to the bike but when I try the 5x reader it does not connect. To make it more complicated it is a 59m not a 5am ECU but afaik 5x reader should work on 59m too. Any one having and experience of this.
As additional information ducatidiag works and I can read the map with that one so my caable and ftdi should be good I think. It also passes the cable test. Any suggestions.
Jocke..............
pauldaytona:
best to contact: guzzidiag at gmail .com
vij:
--- Quote from: pauldaytona on December 13, 2014, 04:28:41 AM ---best to contact: guzzidiag at gmail .com
--- End quote ---
Will do. Thanks Paul
AndySaki:
Did you resolve your Reader connection problems?
Like you, I can connect to my IAW5SM based MV Brutale 910 but the reader fails and the log captured shows that comms were established, baud rates successfully re-negotiated and then a fail with "-2" as the error report repeats 4 or 5 times and then aborts. IAWDiag (and GuzziDiag) connect and monitor flawlessly, and also TPS and CO adjustments work perfectly. Seems curious that the reader can't...
AndySaki:
Log file from a connection attempt.
1540ms Fast init
2046ms Init Ok
2371ms Drawing: 8019BRU52
2372ms Hardware: IAW5SMHW400
2372ms Omologation:
2372ms Software:
2372ms Tester: WLoad1040
2372ms Date: 2007.03.23
2372ms IAW5SM detected
2572ms Diagnostic started
2796ms Diagnostic 2 started
2927ms Baudrate switched
3534ms 57 20 57 21
3535ms 35 68 69 27
3784ms Login Ok
4038ms RequestUpload: -2
4283ms RequestUpload: -2
4527ms RequestUpload: -2
4773ms RequestUpload: -2
5018ms RequestUpload: -2
There's been quite a bit of dialog about connection troubles here, or would I be better contacting GuzziDiag directly?
--- Quote from: AndySaki on January 16, 2015, 11:52:03 AM ---Did you resolve your Reader connection problems?
Like you, I can connect to my IAW5SM based MV Brutale 910 but the reader fails and the log captured shows that comms were established, baud rates successfully re-negotiated and then a fail with "-2" as the error report repeats 4 or 5 times and then aborts. IAWDiag (and GuzziDiag) connect and monitor flawlessly, and also TPS and CO adjustments work perfectly. Seems curious that the reader can't...
--- End quote ---
Navigation
[0] Message Index
[#] Next page
Go to full version