New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
Very cool that you cast the fuse box lid yourself! I think a quick and dirty vacuum pot could be made of a strong paint bucket and a ejector style air fitting. It will obviously not be able to pull down to -0.9 bar or something like that. But I think it would be possible to pull the airbubbles out with less. Might be worth a try. A piece of pipe with ends closed could also be used.
To make a vacuum bottle can I just put the resin filled mold into a sealed container with a spigot attached to a shop vacuum and run the shop vac? I would like to get better results with the clear lids, need to make a couple more for my Moto Morini fuse panel lids.ThanksJim
I definitely think that it is worth a shot. Any vacuum must be better than no vacuum, I would believe that it would take a bit longer to pull out all air bubbles from the mix with a weaker vacuum, but never the less it should help extracting the air. How long is the working time on the resin after mixing? I saw a video on youtube where they are casting a replacement headlight glass for an old 1936 Cadillac and the vacuum pot they are using looks like nothing more than a piece of thick walled pvc pipe (edit: it's a steel pipe) with a thick piece of acrylic on top and sealed by rubber gaskets. I'll try and see if I can find a link. It looks like a doable setup in the home shop. Found it: https://www.youtube.com/watch?v=QMe9MOBjkmcIt goes through all the steps of making the casting, but it is the vacuum pot I thought was interesting. -Ulrik
Hi Jim,Just to follow up on the diy vacuum pot, I just found a video of a guy making one with an old fridge compressor and a kitchen pot. He is able to pull - 0.9 Bar vacuum so it obviously works very well! Just another idea on how to make one. Here's a link https://youtu.be/BeiW_37rS-U-Ulrik
To make a vacuum bottle can I just put the resin filled mold into a sealed container with a spigot attached to a shop vacuum and run the shop vac? I would like to get better results with the clear lids, need to make a couple more for my Moto Morini fuse panel lids.PS - yes to the fluids, just oil and fork oil, the Italian "Made In Italy' decals came in the mail today along with new points, condensers and the correct front axle nut to finish it all off. I am showing the Benelli and the Moto Morini 500 in the vintage display at this years International Motorcycle Show when it rolls into town a week from this coming Friday.ThanksJim
My friend who makes resin jewelry places her molds on top of her running clothes dryer to vibrate out the bubbles
Page created in 0.03 seconds with 21 queries.