1
General Discussion / Re: Fuel injection hose size/type & are clamps necessary?
« Last post by brider on Today at 07:23:29 AM »Depending on where the pressure regulator is on that bike you may have 40-45 psi to deal with.
Regulator must be in the tank as Kev says, it's just straight hose from tank disconnect to a T-fitting then out to injectors @ the manifolds. Measured the barbs and it looks like 5/16", removed plastic line has euro lettering and a 8/1 indicator on it, almost sounds like 8mm ID/1mm wall, which equates to .314" ID, pretty close to .3125". Gonna pick up hose & clamps today and button it back up.