General Category > Bike Builds, Rebuilds And Restorations Only
75/5 restoration evaluation
Alfetta:
Working on rear fender fitment. Here is concept if it is to swing with the rear wheel....
Still pondering this... I like the look but i will have to fabricate us some fender stays... I think i need to define a seat and get a look at the complete package...
faffi:
I like the idea of it, because it can look cool, although I personally think a smooth fender following the arc of the wheel would look nicer than the formed stock plastic unit. It will also add unsprung weight, but not to a degree that it would influence my choice.
Alfetta:
So rear fender fitted.... I can now install drive shaft and flexi boot then move on to the seat options... But now comes my next rant .... I was going to lube the u joint as it feels good gut lube is old. However this looks like another GERMAN gotcha..... I looked at replacement shaft assemblies, but those are stupid priced. So I will have to bring off the original impact stakes and go from there......
Why.... I don't understand.... But so it goes....
Navigation
[0] Message Index
[*] Previous page
Go to full version