Author Topic: voltage regulator swap. do i need to pull the tank?  (Read 234 times)

Offline bertelli

  • New Goose
  • *
  • Posts: 4
voltage regulator swap. do i need to pull the tank?
« on: September 01, 2021, 12:29:03 PM »
v7ii ABS
voltage regulator swap.
do I need to pull the tank or the connector as in visible sight, not hidden under the tank like other connectors?

thanks


Online Antietam Classic Cycle

  • Guzzi Hero
  • *****
  • *
  • *
  • Posts: 12405
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: voltage regulator swap. do i need to pull the tank?
« Reply #1 on: September 01, 2021, 01:35:15 PM »
On my '13 V7 Stone, I just lifted the tank up and moved it rearward enough to access the connector.
Charlie

Offline bertelli

  • New Goose
  • *
  • Posts: 4
Re: voltage regulator swap. do i need to pull the tank?
« Reply #2 on: September 15, 2021, 08:04:48 PM »
On my '13 V7 Stone, I just lifted the tank up and moved it rearward enough to access the connector.

Got it. So you need to remove the tank bolt in the seating area right? Anything else I should know? Thanks

Online Antietam Classic Cycle

  • Guzzi Hero
  • *****
  • *
  • *
  • Posts: 12405
  • Happily stuck in the past.
    • Antietam Classic Cycle
  • Location: Rohrersville, Maryland
Re: voltage regulator swap. do i need to pull the tank?
« Reply #3 on: September 15, 2021, 08:22:51 PM »
Got it. So you need to remove the tank bolt in the seating area right? Anything else I should know? Thanks

It's been two years and the bike is long gone, but I do remember just removing the bolt at the back of the tank. Then I just slid it back and propped it up with some wooden blocks while I replaced the regulator.
Charlie

Wildgoose Chase Moto Guzzi

Re: voltage regulator swap. do i need to pull the tank?
« Reply #3 on: September 15, 2021, 08:22:51 PM »

Offline Kiwi_Roy

  • Guzzi Hero
  • *****
  • *
  • Posts: 9171
  • Location: New Westminster BC
Re: voltage regulator swap. do i need to pull the tank?
« Reply #4 on: September 16, 2021, 05:01:33 PM »
Its probably much easier to remove the tank, you need all the help you can get to access the connectors.
Undo the bolt at the rear, pull it back then undo the pump cable and try to start it.
Starting releases all the pressure from the fuel line which makes it easier to release the quick connect.
You will also have to release the vent line, it's just pushed on.
On my V7III I also unbolted the front coil.
« Last Edit: September 16, 2021, 05:04:45 PM by Kiwi_Roy »
72 Eldorado
17 V7iii Special
76 Convert

Moto Guzzi - making electricians out of riders since March 15 1921


Harper's Moto Guzzi
Harper's Moto Guzzi. Where we still answer the phone, use the highest quality parts, and also do Transmission, rear drive, and carb rebuilds fast. Call us at 816.697.3411 and get your problems resolved.
http://www.harpermoto.com
Advertise Here
 

***Wildguzzi Official Logo High Quality 5 Color Window Decals Back In Stock***
Shipping in USA Only. Awesome quality. Back by popular demand. All proceeds go back into the forum.
http://www.wildguzzi.com/Products/products.htm
Advertise Here