General Category > Bike Builds, Rebuilds And Restorations Only
76 Convert Restoration
Dave Swanson:
This filthy motor was all good news upon teardown. The main bearings and rod shells all look pristine, as do the camshaft and lifters. The cylinder bores, pistons and rings look like they have next to zero wear. The Gilardonis I bought for this project many years ago "just in case" will stay on the shelf.
A number of chrome parts were dropped off at the chrome shop about 60 miles away. They were too far gone to polish and reuse as is for my taste. I also left the stainless fenders with him for a good professional polishing job. I will see these parts again in 8 to 10 weeks, but there is plenty to do in the meantime.
Dave Swanson:
For those that have never seen the Convert torque converter, clutch and 2 speed transmission laid out.
Dave Swanson:
All back together with a complete set of new o-rings and seals. Just need the bits that are going out for zinc plating to completely finish it.
kballowe:
Lookin' good !
:thumb:
Dave Swanson:
For those that would like to see the difference between the early lightweight 2 pc flywheel vs the later 1 pc heavy unit, here you go.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version