General Category > General Discussion

2V Norge valve adjustment

(1/5) > >>

Eric:
I'm curious if anyone has done a video of how to do this. I know there's a trick or two...

guzzisteve:
I do believe there is 1 or 2 out there but can't remember where they are. Try Googling Guzzi Wrench Garage.

Eric:
Did some digging and can't find anything under your suggested search, Steve, or variations thereof. Will keep digging

Bill Hagan:


I did, too, out of curiosity and also came up dry.

There are some step-by-steps how-to's out there but no vids I could find, at least speifically on the Norge.

See if these -- which I, no gifted wrench, dust off whenever I adjust the valves on my Norge and EV -- help:

http://motogoose.com/tech-tips/ev11-valve-adjustment/

http://www.webbikeworld.com/Motorcycle-technical-articles/guzzi/valve-adjustment.htm

Bill

Eric:
Thanks, Bill. Those will be helpful. I'll need to figure out how much of the plastic has to come off. Some have said none. It will be nice if that's the case. I did Lori's baby breva and that was pretty straight forward. And the Ural is easy on the port side because it sticks straight out into the wind. ON the other it's a bit tight. Maybe I'll make a video.  :)

Navigation

[0] Message Index

[#] Next page