New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
Mine is an Ď07 with heated grips and electric windshield with ABS, that makes it a GTL.If yours has a manually adjustable screen it is a GT, at least it is the case for an Ď07. Irregardless...(sic)Yours is a W5AM ECU (like mine). Iíll stand corrected, but your bike wonít connect (digitally), if you enter the wrong model. Just try each one.I cannot comment meaningfully regarding the 15 RC aspect, but mine is...(I think..).I would go and look now, but itís a bit too far away.
What is your plan to re map ?
I had planed on downloading and installing the map for my bike from griso.org, aka Beetle maps.
I installed Guzzi Diag, the reader software, and the windows cable drivers, all for Windows. Unfortunately when I try running the reader software to download my factory map, the reader software says "Connecting..." for maybe 30 seconds and then displays the messages "Initialization failed", "Download was not successful" and "Switch off ignition for at least 10 seconds". I did wait more than 10 seconds and have tried it a few times since. Same results.The cable I bought has a slider switch with 4 settings. I'm wondering if the switch is at the wrong setting. What do you think?
Hmmm, my cables look identical to the ones shown in the PDF guide (page 3) shown here on the griso.org site:https://www.griso.org/GuzziDiag%20for%2015M-15RC-5AM.pdfI have a friend with a cable, will try his. NC Dan called me with some suggestions (put bike in neutral), but still no love.
Thank you PaulDaytona, and everyone else too. I had my cable connected to the 3 wire plug instead of the 2 wire. I am now downloading my original map. So the diagnostic cable works. However the 3 pin adapter I got won't fit the 2 wire plug. I'm using a friend's 3 pin adapter.
Did you reset the learning parameters as well? That's an integral part of the process to ensure you're starting off fresh with the system settings.
I want to buy the correct 3 pin adapter cable. Do you think this one would work?https://www.ebay.com/itm/402338026449It appears to have the longer plug.
Page created in 0.017 seconds with 19 queries.