Dear all
I recently installed an Arrow end can on the V100 and as expected to a degree, there is some assorted popping on over run during deceleration and indicative of lean mixture conditions. As with most modern bikes the system uses dual O2 sensors in a closed loop and one would think it will re-tune itself over a short time.
Does anyone know of a recommended way to force the re-tune? EG; Apparently with Triumph and some others there is a ritual of letting the bike idle until the cooling fans operate a few times, turn the bike off and back on again, stand on one leg and recite the declaration of peace etc. Am sure there is something out there.
thanks