Wildguzzi.com
General Category => General Discussion => Topic started by: Simon_London on December 10, 2018, 04:49:33 AM
-
Can anyone tell me the thread size on Tonti Le Mans 1 and 2 T3 etc swinging arm pivots?
Can anyone tell me what the bearing dimensions are ?
Thanks
Simon
-
I think the pin was an M20 fine thread but I’m too lazy to go to the shed.
Stein Dinse have the online parts listing or Greg bender’s page would list bearing part numbers
-
The thread is M20-1.0. I bought a pair of taps on Amazon for under $20.
The bearing is trade number 30203, which 17 x 40 x 12.
-
Thanks !
-
Do I recollect wrongly, or isn't that the same as the crank sludge trap plug?
The thread is M20-1.0. I bought a pair of taps on Amazon for under $20.
The bearing is trade number 30203, which 17 x 40 x 12.
-
Do I recollect wrongly, or isn't that the same as the crank sludge trap plug?
The crank plug diameter is 22 mm, the thread pitch is 1.25.