General Category > General Discussion
UNI pod filter sizing
Chuck in Indiana:
I'm looking for filters (cheap) ;D for the 36mm pumpers on the aero engine. The carb measures 1.88 diameter. UNI sez they have 1 3/4 and 2 inch diameter. I've never used UNIs before.. which one should I go with? Will the 2 inch tighten down ok?
Oh, and are they flexible?
Antietam Classic Cycle:
Uni pods are very flexible, the 2" should squeeze down fine.
Chuck in Indiana:
--- Quote from: Antietam Classic Cycle on January 14, 2015, 04:08:40 PM ---Uni pods are very flexible, the 2" should squeeze down fine.
--- End quote ---
Thanks, Charlie..
Morizzi:
Chuck,
There are a few types. http://www.uniflow.com.au/contents/en-us/d297.html
Straight with a metal end (buy singly) or a kit that is all foam but angled.
I have used both types with no issue but I'm guessing this is for the Lario. PHF 36s and small block frame so I can't advise on which one will fit better but the angled ones can be rotated to fit most spaces.
Cheers
Rod
Chuck in Indiana:
--- Quote from: Yak Fat on January 14, 2015, 07:21:02 PM ---Chuck,
There are a few types. http://www.uniflow.com.au/contents/en-us/d297.html
Straight with a metal end (buy singly) or a kit that is all foam but angled.
I have used both types with no issue but I'm guessing this is for the Lario. PHF 36s and small block frame so I can't advise on which one will fit better but the angled ones can be rotated to fit most spaces.
Cheers
Yeah, I'm looking at the angled one.. I've never even had a UNI in my hands. If it is flexible enough to bend a little, it won't be a problem.
Rod
--- End quote ---
Navigation
[0] Message Index
[#] Next page
Go to full version