General Category > Bike Builds, Rebuilds And Restorations Only
Headlight switch install...epoxy
Bucky:
The Eldo has all new wiring (ala Greg Bender) and I added his upgraded relays also.
Can't remember if the headlight is on a relay, I don't think so.
Either way, thanks for the replies and will go with a heat treated silver epoxy.
Thanks for the link Charlie....
Bucky
Antietam Classic Cycle:
--- Quote from: Bucky on March 28, 2017, 05:09:23 PM ---The Eldo has all new wiring (ala Greg Bender) and I added his upgraded relays also.
Can't remember if the headlight is on a relay, I don't think so.
Either way, thanks for the replies and will go with a heat treated silver epoxy.
Thanks for the link Charlie....
Bucky
--- End quote ---
If you didn't add Greg's "relay solution" for the headlight (mounts back under the voltage regulator), then I would recommend that you do. It has several benefits: 1) brighter headlight, 2) your new switch won't melt due to the load on it, 3) your fuse block won't melt due to the load on it. :grin:
Bucky:
My mistake....the headlight is on a relay.
Ordered some conductive epoxy. MG Chemical two part silver epoxy.
Expensive, but I only want to do this once.
Thanks all...
Bucky
Navigation
[0] Message Index
[*] Previous page
Go to full version