Wildguzzi.com
General Category => General Discussion => Topic started by: Huzo on September 08, 2021, 12:55:42 AM
-
Today I was heading home on the V85 and the dreaded triangle of death illuminated.
It’s thrown a PO704-invalid signal warning and I looked it up as “clutch switch input circuit malfunction”.
I stopped the bike and upon restart it had cleared.
I looked on Guzzidiag when I got home and it was in the “stored fault” table.
I’ll clear it.
(https://i.ibb.co/7vFypxY/E362183-E-34-F1-43-FF-B46-A-6-E6-B121-CB085.jpg) (https://ibb.co/7vFypxY)
I swear I don’t know if this feature is a blessing or a curse.
Thoughts ?
-
I experienced similar issues on my Cali 1400. It was intermittent.
They share the same 7SM ECU, so it could be relevant.
The clutch switch is a double throw type, but half of it was flakey. Finally was able to nail it down, but a replacement was expensive and unavailable at the time.
I found a Burgess one that was similar physically to the original. If you keep having issues, ping me and I'll send you the details.
-
I experienced similar issues on my Cali 1400. It was intermittent.
They share the same 7SM ECU, so it could be relevant.
The clutch switch is a double throw type, but half of it was flakey. Finally was able to nail it down, but a replacement was expensive and unavailable at the time.
I found a Burgess one that was similar physically to the original. If you keep having issues, ping me and I'll send you the details.
Thanks KD.
I had just washed it so could have been water ingress.