Wildguzzi.com
General Category => General Discussion => Topic started by: Seamaster on June 29, 2016, 02:41:45 PM
-
Has anyone with experience with V7 racer type SHORT after market exhaust system with hepco & becker junior 30 panniers? I already know the difference between racer and stone type exhaust is using different high/low mount and up-swipe angle. I hope the short version of racer after market exhaust is going to fit because I might want to turn my bike into a racer later without have to buy new pips. Thanks!
-
The Racer and Stone also use different length passenger footpeg hangers / muffler hangers.
Your Stone with standard passenger pegs and H+B racks will be a no-go for the upswept Racer exhaust.
-
The Racer and Stone also use different length passenger footpeg hangers / muffler hangers.
Your Stone with standard passenger pegs and H+B racks will be a no-go for the upswept Racer exhaust.
Don't they have conversion kit, I thought.
-
Don't they have conversion kit, I thought.
Yes. Remove the H&B racks. Purchase Racer passenger pegs. Purchase upswept Racer exhaust.
You will not be able to use the H+B racks, without modification, with the racer foot peg bracket.
And then, you will have the issue of the muffler interfering with the bottom of the bag.
-
Don't know the gap between your V7 mufflers & HB bags, but I had a similar issue on my 750 Breva after lowering the position of the bags vs. different upswept aftermarket mufflers. I got some foil/adhesive on 1 side made for sealing exhaust ducts for a water heater from Ace Hdwe. Taped the underside of the saddlebags and they did the job. :thumb:
-
Michael is correct regarding mounting and clearance. The kit is for turning a Racer into a two-up ride; going the other way you buy the required parts a la carte.
Wayne is correct regarding protecting the bottom of the bags using heat reflective or heat insulating material IF you can get a setup that allows the bags to remain with the upswept exhaust.
-
Thanks for the inputs, I just got a pair of Zard exhaust that are little sorted, about 2 inch or so. I have not installed them yet but they look have enough clearance