New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
How about the rear main seal tool? I assume this helps to pull the rear main seal in nice and straight rather than tapping it in bit by bit around the edge
I remove the main bearing flange, press the new seal in with a press. Install with a new gasket and thread seal the bottom two bolts.
Hi there 1 down.Where are you located and welcome. I'm about 100 k North West of Melbourne in Creswick (Ballarat).
Hi Huzo, I'm in Wollongong, just south of Sydney, probably be down your way (ish) for the historic races in a few months.
You�re just down the hill from me. If you want me to whizz off some difficult nuts or pull the rear main flange just stick the bits in the car and bring them up. I�ll probably buy you a beer after it�s done.Pete