General Category > General Discussion

What is this hole in the side of my bike?

(1/3) > >>

WildGuzziNicholas:
The bike is a 2007 Nevada 750
I was trying to remove the plug and accidentally popped the rubber plug inside the case. I tried using a bore scope to find the plug but it's no where to be found. Could this cause a issue if I continue to ride it? What would you recommend doing to retrieve the plug? Thanks.

drdwb:
The hole allows you to view the flywheel and I think clutch plate, it where you look to set the timing. Lots of spinning parts in there to gum up. I wouldn’t leave it in there, and I wouldn’t put the transmission in gear or try to drive the bike until it’s out of there. But that’s just my opinion. Others may not agree, but you’ll want to plug that hole so no water and crap gets in there. Good luck, it’s like losing a guitar pick in the sound hole, but this could seriously mess up your bike.

Wayne Orwig:
The flywheel will shred it. The rubber dust won't hurt a thing. It is to view the timing marks. But you really never need to view them. So, get a replacement plug and don't worry.

moto:
I agree w Wayne. Part number GU93180220. MG Cycle has it in stock.

Dirk_S:
I’d just flip the bike over and give it a good shaking until it falls out.

Navigation

[0] Message Index

[#] Next page