New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
Well, that's because I had the wrong writer
Now that I do, I don't have the "ECU" symbol on the dash and the writer can't initialize. Yet I have data on Guzzidiag.Hmph.
On the Engine Off side it gives you options for Left and Right Ignition - what does that do or is forIn the Engine on bit it refers to "stepper (Idle control) - again what does this do
If I've understood this correctly, the narrow band Lambda sensor fitted to my B11 should cycle roughly 3 times a second between 0.1V and 0.9V, (100-900mV) once the bike is up to operating temperature.I also know that I can see the Lambda voltage displayed in GuzzidiagSo, I know its not precise but can I infer that if the voltage displayed is outside the parameters above (cycles only once a second for example) I have a faulty/sluggish Lambda sensor
It works fine with Win10...took me less than 12 minutes for the whole save/write/reset TPS routine...the first page of the thread is all you need...you have a config or install problem...McAfee is NOT state-of-the-art software...
I'm sorry the tutorial isn't written in "Spoonfed 101" language. The first post on the Reader tells you how to backup your map. It doesn't say "you must do this first". For Windoze users, this howto also says to download correct drivers. The guzzidiag software runs fine on Windows 10. And Linux. And MacOS. I'm sorry if I assumed you might have a clue how to use a computer.
Yea, I know, I'm a dumb female who has difficulty finding the power switch...