New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
The only time you ever re-set the TPS on a single TB model is after it has been re-mapped and even then on the newer V7-II's they don't recommend it after 3,000km due to wear in the shitty plastic cam wheel.
Who re-mapped it? They should of recalibrate do it afterwards.
Revan, you're wasting your time with guzzidiag until you get the bike properly tuned. Get it as good as it gets before changing stuff. All you'll end up doing is double work.
Hi, guys.Thanks for the responses.OHHH....so the light IS supposed to come on, even when the 3-pin is not hooked up to anything!!!??? Ok....so then I DO have a hardware problem......Becaus e when I connect it to a power supply, nothing happens....the red light on the FTDI connector does not come on at all unless I plug the 3-pin connector into something. Well....time to order a new 3 to 16 pin connector :/Revan.
Not so fast - let's make sure we are being clear!The adapter (3 to 16) cable should have AT LEAST one cable coming out with a clip on the end. Most have two - a positive and a negative. The adapter will get POSITIVE power through the clip cable (to your battery positive terminal) and will access ground through the wiring of the 3-pin plug on the bike AND the alligator clip wire if it is present. IF you clip the wire to the positive terminal and DO NOT plug the 3-wire connector to anything on the bike, there is no ground (unless you also have and use the negative alligator clip).In other words, the red light on your cable's connector head needs both positive and negative connections to operate - and they must come through that 3-16 adapter cable's connections to the bike.
Yeah......my 3-16 pin is the one with both leads (positive and negative). The FTDI connector does work, the light will come on when I plug it into something that has a powered circuit to it (like when I plugged it into my cars 16 pin diagnostic port).....so now the only thing that I can think of, is that it must be that the power leads on the 3-16 pin connector are not correctly feeding the FTDI unit power at all........unless I'm missing something else.Revan.
Hardware failure. Something I had not considered (and should have). Bugger! Well, may have to consider ordering a new one. Is there a "better" one you can recommend?
Version 3.2?? I only see 2-3.5