General Category > Bike Builds, Rebuilds And Restorations Only
‘79 Spada Refresh
Canuck750:
Nice work! its going to be a good, dependable ride.
Scout63:
--- Quote from: Canuck750 on December 08, 2021, 08:37:43 PM ---Nice work! its going to be a good, dependable ride.
--- End quote ---
Thanks Canuck. I’m walking a fine line of updating everything while it is crabbed but also keeping the cost down so that I can flip it towards a Lemans. It’s hard not to make everything right. If I can keep my investment below about $3500.00 US, which is coming up soon, I should break even not counting labor.
Scout63:
Clutch inner and outer bodies and throwout bearing need replacement, new rear main seal, new flywheel bolts, clutch plates, intermediate plate and ring gear bolts, gearbox disassembled and flushed, bearings checked. New gearbox output seal.
q
Scout63:
Gearbox reassembly. Always my most difficult part.
q
Scout63:
Gearbox complete. They always give me fits. 6 pushrod o- rings and new inner and outer bodies and thrust bearing.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version