General Category > General Discussion

Need help and advice

<< < (7/7)

Huzo:

--- Quote from: willowstreetguzziguy on August 31, 2026, 03:46:45 PM ---Sorry, I meant “Idling”. I don’t have Guzzidiag or manometer. I just thought there might be a simple, easy way to lower the rpm’s.

--- End quote ---
The SS will always stop the plate at the correct point if it has not been messed with. You “tell” the ECU that it is 4.6 degrees when at that point when you reset the TPS.
From there it is solely the stepper’s function to manipulate the mixture to achieve the target idle of 1150 rpm.
Try spraying some WD40 or similar into the stepper by whatever means you devise.

CoolBreezeBreva:
Try putting it in neutral? That usually drops the idling rpms a bit on my Norge

willowstreetguzziguy:
I spoke with Jim Hamlin this morning, he’s the one I’m taking it to on September 8. I mentioned the idle is sitting at 3500 RPMs. He recommended turning the sacred screw back out. I turned it one turn out and it dropped the idle to 1200 RPMs. Took it out for a ride and it’s never ridden smoother with great acceleration. The backfiring is still there so I will take it to Jim and see if he can work his magic on it.

Navigation

[0] Message Index

[*] Previous page

Go to full version