General Category > Bike Builds, Rebuilds And Restorations Only
850T Project Cafe Bike
cappisj1:
The gear shift side. I used the adaptor included in the kit. I had it welded to a new rod the replaced the original rod that runs under bike from side to side. Had to bend the tab in this side also.
twowings:
Tasty! :bow:
swooshdave:
--- Quote from: cappisj1 on February 03, 2017, 02:50:04 PM ---The gear shift side. I used the adaptor included in the kit. I had it welded to a new rod the replaced the original rod that runs under bike from side to side. Had to bend the tab in this side also.
--- End quote ---
Would it have been easier to switch to right side shift?
canuck750:
Nice job! Enjoy the ride.
arveno:
--- Quote from: cappisj1 on January 28, 2017, 12:16:12 AM ---Pulled both cylinders to check the chrome lining. All was good. Notice the high dollar ring compressor.
you decided you run the original cylinders ? Chrome bore ?
i am sure you know the story.... nice bike .
--- End quote ---
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version