New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
This ^^^^ is what eye dew.
None of the above I think is wrong.But I’d not use the nut to bed the races by pulling them up “very tight”. It’s a bit cruel to brutally force the inner and outer together with that level of force.If you freeze the inner and (perhaps) warm the housing, they should fall in. But I do appreciate the need to have them properly seated.A simple tool can be made in the form of a long bolt and two discs, with the the bolt through the stem and the discs drawing the races together.
I just greased and replaced the upper and lower tapered bearings on my ‘03 Stone project. First time doing this kind of work on any bike and putting it all back together, even after watching vids and trying to research on here, I’m confused as to how tight I should go down on the top spanner nut? Any advice appreciated here. I first tightened them down very tight to try and set the bearing, then I backed it off but confused how tight it should be. Should I feel any resistance when turning the tree? A little resistance? None? Is it splitting hairs? Thanks.