General Category > General Discussion
NGC, vintage V8 spewing coolant but not overheating....
brider:
I have a chronic issue with an old Range Rover with the Buick 4.2L clone V8; it continually spews coolant out of the reservoir cap (which is where the system relief calve is), but never overheats, as I would expect if there were a leaking head gasket. No white smoke, starts, runs, & idles just fine.
The only things I can think of that would cause this spewing would be:
A), bad reservoir cap, allowing system to release too early (system/cap is I think a 16 PSI rating?).
Or,
B), exhaust pressure in the system. I had the system checked YEARS ago when this was also happening and it came up neg, I know that means nothing now. But wouldn't there be other symptoms? White smoke? Rough running? Overheating? None of that, purrs like a kitten.
I have a contraption to add VACUUM to the cooling sys, is there something similar to pressurise the sys to see if the cap IS releasing too early? Should I just buy a replacement cap? I did that also years ago with no lasting improvement.
73 sport:
If your buick V8 is an aluminum block, it is incompatable with many antifreezes. A goop is formed that plugs up the radiator.
brider:
I've been running green generic coolant in it for 15 yrs, radiator was re-cored but there wasn't/isn't any evidence of excessive goopiness.
michaell32:
A weak radiator cap can do that. Also if they gauge just shows red and green or c and h I wouldn't rule out that it's not overheating. Ive seen cars hit 250 and the gauge was just over half way between the c and h. Go off the obd2 scanner if it's newer than 96.
cliffrod:
A Stant 12270 pressure tester like this kit will test radiator and caps. It may need an adapter to fit your specific cap. These are very handy for checking the system for leaks and pressure. Here’s a link to one on eBay-
https://www.ebay.com/itm/298633056769
Other companies make them. I’ve always trusted Stant for them when working on my old cars.
Typically, If it spits out coolant but doesn’t run hot, it’s a simple overfill issue. Sometimes filling it to FULL on the resevioir need to be done when it’s cold, not hot.
Navigation
[0] Message Index
[#] Next page
Go to full version