General Category > Bike Builds, Rebuilds And Restorations Only
New G5 Project
Groover:
Have you played around with the low-end needle adjustment? Screw it in all the way, then back it our a few turns as a starting point. Screwing it out is to richen, screw in to lean it.
This one:
Antiquar:
--- Quote from: Groover on April 20, 2017, 11:46:45 AM ---Have you played around with the low-end needle adjustment? Screw it in all the way, then back it our a few turns as a starting point. Screwing it out is to richen, screw in to lean it.
This one:
--- End quote ---
I have, but if I have the jets on hand I like to try. :laugh: In fact, I popped the 50s back in and the idle was definitely too lean. I replaced the 60s and was able to achieve a decent idle with the mixture screw.
I think the main might be a tad too rich but I'm going to ride it as is for a while.
Navigation
[0] Message Index
[*] Previous page
Go to full version