New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
Hi guys quick question on routing fuel lines. I'm using the dual banjo setup, does it matter if the fuel lines go below the carbs? Looking at some pictures it looks like it's OK if they do so. Or do they need to stay above te floats for gravity to pull fuel? Trying to find cleanest install I can and it seems like going under might be helpful. Thanks.Also, do people ever run fuel lines diagonally, as in right petcock feeds left carb and vice versa?
Thank you, fuel lines installed, petcocks installed with stainless stand screens from John G. On the left side the it seems like the petcock switch is really close to the cables coming off the carb, does that look OK?Any suggestions on retaining clips for the fuel lines?Next is getting the carbs set up/tuned. Is this doable without special tools? I've been starting to research it, will plug away at it.
OK cool. I used "CLEAR MOTION PRO PREMIUM FUEL LINE, 5/16", 3 FEET" from MG CYCLE:https://www.mgcycle.com/index.php?main_page=product_info&cPath=30&products_id=4439Let me know if that's a problem! OK, on to the carbs...
So I can do without it? At least for now? If so, I'm close to trying to start it I think! I bought a gallon of premium fuel. Waiting for the fuel line clips, arriving tomorrow I think. Haven't changed the oil, but it's Ok to start start it? Will do full oil change before riding.
Sure, won't hurt anything as-is. I'd dump the oil that's in it and start fresh. 3 qts. only.
So change the oil before trying to start it? I can do that, but thought I should get it warm before draining oil. Not sure why I thought that, but I can drain oil while cold and refill. What kind of oil do you recommend?I'm excited to see it running, have had the bike almost two years without it running lolol!!
So I thought I would just crank the engine before adding fuel, just to check. I got nothing when pushing start button. Clutch was engaged. Couldn't get neutral light to come on, and not familiar with gears to know if I found it or not. Battery is showing 12 volts. I guess I need to start checking continuity of electrical wiring... Any suggestions? Is there some some special condition that needs to be met for start button to work?
Your Ambo may still be wired so that the starter will only engage if the transmission is in neutral. It's easy to tell and fix - if there is both a green wire and black wire connected to the neutral switch stud, then it will only start in neutral. If you want it to start in gear, then the green wire will remain on the neutral switch stud, but the black wire should be connected to a nearby bolt on the transmission case. Remember that the shift pattern is "backwards" - one up, three down - so you may not be in the "real" neutral.
OK that was it. I tried to move black wire to one of the bolts holding on the neutral switch, but I can't thread the bolt back in. I haven't tried very hard but it's definitely meeting some resistance a few turns in. Hope I haven't damaged threads. Guess I'll have to try and chase it out?So I attached black wire to a different bolt and it cranks. Let fuel flow and it cranked for a bit but no joy. Now won't crank, maybe I wore down the battery, need to check voltage tomorrow. Thanks for the help!
OK thanks guys! Will try that today, hopefully I have the correct feeler gauge already. I'm supposed to advance the rear wheel until the points open up or something? Any guide/tutorial somewhere for this, I looked on This Old Tractor but didn't find.Also what do you think of the Guzziology book? I noticed Greg Bender recommended it, thought I might get a copy?
Was that running on choke?
Page created in 0.021 seconds with 19 queries.