« previous next »
Pages: [1]   Go Down

Author Topic: Breva V1100 ignition switch  (Read 837 times)

Offline tris

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • Posts: 2803
  • Location: United Kingdom
Breva V1100 ignition switch
« on: March 26, 2016, 04:43:14 PM »
The ignition switch on the B11 is a tad sticky.
Any reason why it shouldn't be treated to a shot of WD40 or similar?
Cheers
Logged
2017 V9 Roamer
2005 Breva 1100 (non ABS) "Bruno" - now sold
1995 Cali 1100 - carby   "Dino" -now sold
1993 TW125 "POS" - Resting

Offline boatdetective

  • Gaggle Hero
  • *****
  • Posts: 2985
Re: Breva V1100 ignition switch
« Reply #1 on: March 26, 2016, 07:20:46 PM »
You might consider a specific lock lube. It's usually graphite suspended in light solvent. The solvent acts as a vehicle to transfer the graphite to the working bits. When the solvent dries up- you're left with nice slippery graphite.
Logged
Jonathan K
Marblehead, MA

1981 V50III "Gina"
2007 Griso 1100 "Bluto" (departed but not forgotten)
2003 EV "Lola" gone to the "Ridin' Realtor" in Peoria
2007 1200 Sport "Ginger"

"Who's the cat who won't cop out, when there's danger all about?"  -Isaac Hayes
20 Ounce Stainless Steel Double Insulated Tumbler
Buy a quality tumbler and support the forum at the same time!
Better than a YETI! BPA and Lead free.
Advertise Here
Pages: [1]   Go Up
« previous next »
 

Quad Lock - The best GPS / phone mount system for your motorcycles, no damage to your cameras!!
Get a Wildguzzi discount of 10% off your order!
http://quadlock.refr.cc/luapmckeever
Advertise Here