New 20 ounce tumblers available now! Forum donation credit with purchase. https://www.wildguzzi.com/Products/products.htm#Tumbler
Trim the fork covers? They keep the road crap off the stanchions (tubes? what are they called on USD forks?). I would be concerned that the seals would see a lot more wear.If you don't like whatever pyramid plastics has to offer- then just roll your own. I used a piece of neoprene, cut to a sort-of triangle shape, that is unobtrusive. Cost less than a (US) dollar.
I needed to arrange some protection for the front of the engine and thought I would have the most success with a low mounted guard.I don’t suggest it is more attractive, but when done in red, it will begin to blend..Before..After..Walk around..https://youtu.be/bT5mUS3_EKA
I already have two in my pants...
That looks really good. I'm surprised that the fender originally sat so close to the wheel.
Hey Huzo, you're a trend-setter! Mistral now offers 'big bore header pipes'https://www.mgcycle.com/index.php?main_page=product_info&cPath=26_336&products_id=5675Cheers,jrt
Putting these on my new V85tt when it is ready to pick up, mounting on the crash bars. Will run through a Skene controller to make them drl's as well as spots.https://www.stedi.com.au/25-cree-led-motorcycle-driving-spot-light.html
Just thinking.... would a short - say 150-200mm - LED lightbar fit where the upper 'guard had been removed? I have one mounted to the handlebars of my Nuda, which makes a world of difference at night: greater penetration & spread. This would still leave room for a pair of crashbar mounted foglamps wired to the low beam circuit. Vaguely reminiscent of a Mod's Vespa from the '60s? Without all the mirrors of course.
Mounted my Spots today, only wired through standard relay to work with High Beam though. Will put my Skene controller in when the propper loom fittings arrive.Work extremely well, 25w Stedi Spot beam.
a world of difference at night: greater penetration & spread.
Is it possible to get a night time shot of them in use and give us a bit of a report ?I am going to get a couple, but did not know whether the Touratech or Denali was a worthwhile course.
Got the wiring bits I needed and now have running lights and spots.Low beam Low beam High beam
Are they LED ?
I like that yours are 'cleaner'. Do I recall correctly that you have the O2 monitor bungs downstream a bit? They are well hidden. Personally, I could do without the tangs to fit the skid plates. I don't do that kind of riding on this bike.