Author Topic: Resr end ticking  (Read 607 times)

Offline shai385

  • New Egg
  • *
  • Posts: 41
  • Location: israel
Resr end ticking
« on: April 27, 2021, 03:27:34 AM »
Need some advice, I have  a center  stand  on my  v7 iii
When  I turn the wheel  ,while  the engine  is not  running
I hear  some  noise  from  the rear end,like parts  are moving  inside, as if I turn a wheel  that  has  sprockets  and chain
I looked  at another  guzzi, and its completely  silent, no noise  at all while  turning  the wheel, when  driving  I don't  hear  any  strange noises, I guss  without  the  stand  I wouldn't  have  noticed, is it normal  noises?or a beginning  of a problem?
Thanks


Offline skippy

  • Gaggle Mentor
  • ****
  • Posts: 729
Re: Resr end ticking
« Reply #1 on: April 27, 2021, 04:39:20 AM »
You may just be hearing the the brake pads dragging on the rear disc. The pads are always just barely touching the disc ready to grab when the brake is applied. Any bike with disc brakes will have the same sound to some extent.

Skippy
23 V100 Mandello
20 V85TT

Offline shai385

  • New Egg
  • *
  • Posts: 41
  • Location: israel
Re: Resr end ticking
« Reply #2 on: April 27, 2021, 06:24:41 AM »
Thanks, but it not  the brakes

oldbike54

  • Guest
Re: Resr end ticking
« Reply #3 on: April 27, 2021, 06:28:36 AM »
 It could be a normal sound , how much slop is in the driveline ?

 Dusty

Wildguzzi.com

Re: Resr end ticking
« Reply #3 on: April 27, 2021, 06:28:36 AM »

Offline Huzo

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • *
  • Posts: 13192
  • Location: Creswick Australia
Re: Resr end ticking
« Reply #4 on: April 27, 2021, 06:35:45 AM »
When the bike is on the stand, the uni is going through an unnaturally large angle.
Try taking off the shocks while on the centrestand and prop the swingarm up to the position it would be if it was laden.
You might find the noise disappears.

Offline Vagrant

  • Gaggle Hero
  • *****
  • *
  • *
  • *
  • *
  • *
  • Posts: 2132
  • Location: Gainesville, Ga or Green Valley Az.
Re: Resr end ticking
« Reply #5 on: April 27, 2021, 06:55:56 AM »
My III has the HB CS and does the same thing. Sounds like the shaft or U joint is hitting the housing. V700 Steve installed mine and said don't worry about it, so I haven't. It's gotten 17000 on it and is still fine.
It does make me wonder what happens when people put longer than called for rear shocks and go over a severe bump and the thing really hits. 
HE IS FREE WHO LIVES AS HE CHOOSES
2016 V7II, 2017 V7-III Blue special, 2022 V85 the fast red one! 2016 650 Versys
L-196, L-197

Offline shai385

  • New Egg
  • *
  • Posts: 41
  • Location: israel
Re: Resr end ticking
« Reply #6 on: April 27, 2021, 08:16:00 AM »
When  I roll ithe bike down  a slope   I don't  hear  any  noises ,when the engine  is off
If anyone  who has a center  stand  can try  it I will really  appreciate

Offline shai385

  • New Egg
  • *
  • Posts: 41
  • Location: israel
Re: Resr end ticking
« Reply #7 on: April 27, 2021, 08:25:40 AM »
What  is HB CS?

Offline guzzisteve

  • Gaggle Hero
  • *****
  • *
  • Posts: 11406
  • "Just Ride It"
Re: Resr end ticking
« Reply #8 on: April 27, 2021, 09:42:47 AM »
Listen over by the ujoint rubber, I think that's were the noise was on Vagrents. Maybe some stretch out farther than others, only happens on the centerstand. Nothing to worry about. You could listen on the end of a screwdriver also with tip on affected area.
"Pray through Carlo & your bike shall be healed"
Location: Planet Earth

Offline Wayne Orwig

  • Gaggle Hero
  • *****
  • Posts: 13906
    • Hog Mountain weather
  • Location: Hog Mountain
Re: Resr end ticking
« Reply #9 on: April 27, 2021, 09:46:41 AM »
Likely just a touch of movement in the splines. Take it apart, pack the splines with goo, see if it changes.
At may even be the bearings rattling a touch on the pinion rings. The best fix is to not listen to it when it is on the center stand.
Scientist have discovered that people will believe anything, if you first say "Scientists have discovered...."

***Wildguzzi Official Logo High Quality 5 Color Window Decals Back In Stock***
Shipping in USA Only. Awesome quality. Back by popular demand. All proceeds go back into the forum.
http://www.wildguzzi.com/Products/products.htm
Advertise Here
 

***Wildguzzi Official Logo High Quality 5 Color Window Decals Back In Stock***
Shipping in USA Only. Awesome quality. Back by popular demand. All proceeds go back into the forum.
http://www.wildguzzi.com/Products/products.htm
Advertise Here