Wildguzzi.com
General Category => General Discussion => Topic started by: Aaron D. on August 09, 2015, 10:48:27 AM
-
Good morning,
I just noticed my mc perch is cracked halfway through. Not sure how long it's been this way, I was preparing to do a fluid change when I noticed.
No luck searching on MG, I can call Harpers tomorrow, but is this a common bit or is it something special?
I could make one but I would prefer to have an OEM style bit there.
Thanks!
-
The Brembo master cylinders are common between Ducati, Aprilia, and Guzzi.
I'd take a look at Ebay for a Ducati take-off.
Look at the backside of yours to confirm the piston size, and that it matches whatever replacement you buy.
-
Mine broke, I made a new one out of steel. Not difficult and looks OK.
-
Mine broke, I made a new one out of steel. Not difficult and looks OK.
You made a whole perch, or you made the clamp?
-
oops my mistake I thought he was talking about the aluminum doohicky that holds the brake reservoir.
-
It is the aluminum doo-hickey, darned thing cracked at one of the "lightening" holes.
It would be pretty easy to make a new one, just thought I'd buy my way out of this.
-
https://www.af1racing.com/store/Scripts/prodView.asp?idproduct=3121
-
So the part is called a "tank support", and is an $8 part at Harpers. Go figure.
I guess I'll make sure my bleeders aren't terminally seized before I order it, because calipers aren't too pricey either.
-
So the part is called a "tank support", and is an $8 part at Harpers. Go figure.
I guess I'll make sure my bleeders aren't terminally seized before I order it, because calipers aren't too pricey either.
If you are going to replace them 999 ducati calipers offer a significant upgrade.
-
Thanks, I'll keep it in mind if needed-still hoping to find the little bracket first though,