General Category > Bike Builds, Rebuilds And Restorations Only
1973 v7 Sport refresh
Scout63:
I finally got some time on the V7 today. Crank and rods installed as well as rear main seal, oil pump and most of the oil system gaskets. I forgot to check to make sure that the rear bearing oil dowel is in place so off it comes again tomorrow.
Klinkhammer:
Had the flywheel in my (now sold) V7 sport lightened by HMB. I enjoy the engine characteristic it gives.
Your work is, as always, excellent!
Scout63:
--- Quote from: Klinkhammer on May 03, 2023, 12:39:06 PM ---Had the flywheel in my (now sold) V7 sport lightened by HMB. I enjoy the engine characteristic it gives.
Your work is, as always, excellent!
--- End quote ---
I love that picture Klinkhammer.
spmoto:
Hey Ben,
Curious as to why the PO saw the need to balance the crank. Isn't that typically done when going with a big bore kit? Have you measured the bores?
Dave Swanson:
Always a worthy candidate for TLC. Good going! This brings back memories.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version