Need I have to remove the LH structural plate that mounts foot pegs also to reach the solenoid? I want to piggyback a wire to an aux starter button under the seat but cannot seem to reach it.
The bolts that you see have to come out and there’s one down the bottom IIRC.
The gear lever has to come off, requiring removal of that little black cover over the spline, but that’s good, because you can grease the pivot..(and probably replace the dry from new, worn out bush…)
I’ve had mine off to replace/grease/adjust the swingarm races.
But as mentioned before, I have had my starter off by doing nothing more than disconnecting the cable and solenoid wire, then undoing the two bolts holding it on.
It WILL come out.